


Choosing Quality Oil Seals:
Leather Oil Seals - Leather Seals, also known as Type L Oil Seals, are most common in components that are subject to dirt and poor lubrication. Since they come pre-lubricated and are able to absorb fluids, leather oil seals are able to provide sealing properties in conditions that synthetic rubber is unable to.
4. Protecting the shaft from damage helps optimize your oil seals’ efficiency.
Rubber Components like Oil Seals, O Rings, Gaskets, Bushes, Rubber to Metal Bonded Parts, Packaging Sets, Cloth Seals, etc are constantly developed and supplied as per consumer requirements.
When installing a 38x52x7 oil seal, it is important to ensure that the seal is properly lubricated and aligned with the shaft. This will help to minimize friction and wear, and extend the life of the seal. It is also important to regularly inspect the seal for any signs of damage or wear, and replace it if necessary to prevent oil leakage.


Lubricant Amount - Seals will always perform best when lubricated, however in some machines there are more likely to be dry spells. For these cases, selecting a leather or PTFE seal will be beneficial, as both can operate with less lubrication than others.
Obtaining adequate adhesion of fluoroelastomer compounds to metal inserts is a major consideration in fabrication of shaft seals. Adhesive systems worked out for bisphenol-cured VDF/HFP/TFE elastomers often do not perform adequately for peroxide-curable fluoroelastomers and more base-resistant polymers that contain little or no VDF. The trend toward use of more resistant fluoroelastomers in shaft seals has necessitated considerable effort on compounding and adhesive system development to get adequate bonding of the new materials. Silane-type primers are often used to coat metal inserts; these contain residual active groups such as amine functions that interact with the fluoroelastomer compound to attain good adhesion, especially for VDF/HFP/TFE elastomers. Other adhesive systems, using epoxy compounds or tie-coats, may be necessary for difficult bonding situations.3