Post time: 22-07-22
Post time: 03-04-23
Post time: 10-08-22- Wire mesh even in the mining industry also has a higher reflection, because the selection of low-carbon materials to do the material so that it has a general iron net class does not have flexibility, concluded that its plasticity in use, and then can be used in hardware crafts deep processing production, as the wall plastering, leak prevention crack and so on. Its light net body, lower cost, more can let customers experience its economic benefits.
Post time: 18-05-22- Whether the wire rope is chosen correctly or not directly affects the service life of the rope and causes the structural deformation, fracture and unexpected failure of the rope. Therefore, the selection principle is as follows: when the progress of unguided heavy objects is made once or repeatedly at a larger height, the non-rotating wire rope is selected:
Excellent anticorrosive makes its popularity in the feed, the net surface smooth and tidy, increased the look and feel, can be adornment effect, this characteristic makes it to show in the mining industry, due to high quality with low carbon materials as raw materials, to make it unique general iron mesh screen does not have flexibility, determine its plasticity in use process, Thus can be used in the hardware process of deep processing and manufacturing, complex wall batch swing, underground leakage prevention cracking, light mesh body, so that the cost is much lower than the cost of iron screen, more able to understand its economic and practical.
- The form of installation: in the top with the various cage tied together at least as wrapped stone cage net that combination closely not easy to use bad. If the local bandaging is appropriate, it can increase the stability of the structure. There are a lot of grid edge, if the stone cage net only hook in the cage edge and not prepared in the cage edge, even in loose.
Steel wire after galvanized treatment, the surface will be covered with a layer of zinc metal, to play the role of anti-corrosion, anti-fouling, enhance strength and beauty. The galvanized wire drawing treatment is to process the steel wire by stretching method to obtain a finer, higher strength and smoother surface, and improve its mechanical properties. However, will wire drawing affect the electrical conductivity of galvanized steel wire?
Post time: 26-04-23In order to pack and bundle galvanized wire on the surface of the deposit layer to remove the surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless. Small homogeneous particles of large denier present in the tank can stabilize the foam layer. To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the intake of surfactant. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.
- 4, after brushing, rinse with water. It should be noted that dogs like to lick everywhere. The disinfectant left on the fence is easy to be eaten by dogs, so be sure to flush several times. Finally, take the dog cage to the sun for 1 hour, ultraviolet radiation will make the sterilization effect double!
Post time: 11-10-22- 2, line diameter, mesh spacing (refers to the edge of the twist to the opposite side of the distance).
Post time: 03-11-22- ① The diameter of galvanized iron wire for drawing shall not be less than 4mm, and the diameter of galvanized iron wire for binding shall not be less than 2.6mm.
Post time: 11-11-22
Post time: 20-09-22Defects such as surface film and surface inclusions can be found and treated by conventional techniques in order to remove them locally from the surface of the deposition layer. Excess foam is formed when soap and surfactants such as saponified fats are brought into the tank.
Regarding the placement of the cage, the top of the cage should not be higher than your standing eye level. This is because tall parrots are usually superior and not easy to tame. But for overly frightened parrots it can be slightly above your eye level. The bottom of the cage is usually equipped with a tray to prevent objects such as bird seed from falling to the ground and to prevent parrots from bumping their feet through the bars at night. The chassis should be covered with newspaper and replaced daily. To help the parrot feel safer, the cage should have a solid side and not be surrounded by bars. If a solid side is hard to find, put one side of the cage against a solid wall.
- 4. Substrate material: The substrate material of electrogalvanized wire also has a certain impact on its corrosion resistance. The substrate of different materials has different chemical properties and electrochemical activities, and the corrosion performance is different under different environmental conditions, and the compatibility with zinc layer will also have a certain impact on the corrosion performance.
Post time: 27-04-22- Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four faces of the asbestos block are used up, maintenance workers can continue to use the asbestos block after repair when necessary to reduce the consumption of asbestos block.
The formation process of hot dip galvanized layer is between the iron matrix and the outside of the pure zinc layer, the formation of iron-zinc alloy process, the workpiece surface in hot dip plating when the formation of iron-zinc alloy layer, so that the iron and pure zinc layer is well combined. The process of large roll galvanized wire can be simply described as: when the iron workpiece is immersed in the molten zinc liquid, the first zinc and α-iron (body-centered) solid melt is formed on the interface. This is a crystal formed by the matrix metal iron dissolved with zinc atoms in the solid state. The two metal atoms are fused with each other, and the attraction between the atoms is relatively small.
- Generally larger birds choose tall but more dense cage, so as not to damage the tail feathers. Although bailing and other small body, but high flying singing habits, with a special high cage.
The barbed rope factory will store the blade barbed rope in a suitable place when it is stored, because it understands the product characteristics.
- The material of wire mesh can choose galvanized wire, stainless steel wire, copper wire, coated wire, lacquer wire, etc., different materials are used in different fields, such as construction, culture, decoration, etc.
- 5, there are no special requirements: such as whether to shrink packaging, etc.
- Third, after the production process of cold galvanized wire treatment. Galvanized cold galvanized wire needs to go through a series of post-treatment processes to ensure its quality and performance.
Hot dip galvanizing is also called hot dip zinc and hot dip galvanizing: is an effective way of metal corrosion, mainly used in various industries of metal structure facilities. It is to immerse the steel parts after rust removal into the molten zinc liquid at about 500℃, so that the surface of the steel parts is attached with zinc layer, so as to play the purpose of anticorrosion. Hot dip galvanizing process: finished product pickling – washing – adding bath aid – drying – hanging plating – cooling – drug – cleaning – grinding – hot dip galvanizing completion. Hot dip galvanizing is developed from the older method of hot dip galvanizing. It has a history of 140 years since it was applied to industry in France in 1836. However, the hot dip galvanizing industry has been developed on a large scale in the past 30 years with the rapid development of hot dip galvanizing wire.
- 1, prepare for the bird cage
Pet cages can be used for indoor and outdoor pet houses. The dog cage is equipped with a fixed food basin and a drinking device, and the rubber pad of the pet cage with a bayonet on the four sides can be assembled. Can be splicing according to the size of the cage, shear, disassembly convenient, easy to clean, can solve the puppy in the ordinary cage pinched foot problem, prevent the puppy in the development of adverse reactions. The bulkhead of the pet cage is breathable and comfortable, which can be used as a heat shield for pets in summer. A puppy with small feet, not a foot, not a pinch.