Traditionally, UV-filters are categorized as either chemical or physical. The big difference is supposed to be that chemical agents absorb UV-light while physical agents reflect it like a bunch of mini umbrellas on top of the skin. While this categorization is easy and logical it turns out it's not true. A recent, 2016 study shows that inorganic sunscreens work mostly by absorption, just like chemical filters, and only a little bit by reflection (they do reflect the light in the visible spectrum, but mostly absorb in the UV spectrum).

The skin of an adult person is, in most places, covered with a relatively thick (∼10 μm) barrier of keratinised dead cells. One of the main questions is still whether TiO₂ NPs are able to penetrate into the deeper layers of the skin. The majority of studies suggest that TiO₂ NPs, neither uncoated nor coated (SiO₂, Al₂O₃ and SiO₂/Al₂O₃) of different crystalline structures, penetrate normal animal or human skin. However, in most of these studies the exposures were short term (up to 48 h); only few long-term or repeated exposure studies have been published. Wu et al.83 have shown that dermal application of nano-TiO₂ of different crystal structures and sizes (4–90 nm) to pig ears for 30 days did not result in penetration of NPs beyond deep epidermis. On the other hand, in the same study the authors reported dermal penetration of TiO₂ NPs with subsequent appearance of lesions in multiple organs in hairless mice, that were dermal exposed to nano-TiO₂ for 60 days. However, the relevance of this study for human exposure is not conclusive because hairless mice skin has abnormal hair follicles, and mice stratum corneum has higher lipid content than human stratum corneum, which may contribute to different penetration. Recently Sadrieh et al. performed a 4 week dermal exposure to three different TiO₂ particles (uncoated submicron-sized, uncoated nano-sized and coated nano-sized) in 5 % sunscreen formulation with minipigs. They found elevated titanium levels in epidermis, dermis and in inguinal lymph nodes, but not in precapsular and submandibular lymph nodes and in liver. With the energy dispersive X-ray spectrometry and transmission electron microscopy (TEM) analysis the authors confirmed presence of few TiO₂ particles in dermis and calculated that uncoated nano-sized TiO₂ particles observed in dermis represented only 0.00008 % of the total applied amount of TiO₂ particles. Based on the same assumptions used by the authors in their calculations it can be calculated that the total number of particles applied was 1.8 × 10¹³ /cm² and of these 1.4 x10⁷/cm² penetrated. The surface area of skin in humans is around 1.8 m²  and for sun protection the cream is applied over whole body, which would mean that 4 week usage of such cream with 5 % TiO₂ would result in penetration of totally 2.6 × 10¹⁰ particles. Although Sadrieh et al.concluded that there was no significant penetration of TiO₂ NPs through intact normal epidermis, the results are not completely confirmative.

Rebecca Capua is an assistant conservator in the Paper Conservation Department at the Metropolitan Museum of Art since 2009. She received an MA in art history and an Advanced Certificate in art conservation from the Conservation Center, Institute of Fine Arts, New York University in 2007. Her primary area of research is on the materials of American artists of the late 19th and early 20th century. Address: The Sherman Fairchild Center for the Conservation of Works on Paper, Metropolitan Museum of Art, 1000 Fifth Avenue, New York, NY 10028. Email: rebecca.capua@metmuseum.org.

Although barium sulfate is almost completely inert, zinc sulfide degrades upon exposure to UV light, leading to darkening of the pigment. The severity of this UV reaction is dependent on a combination of two factors; how much zinc sulfide makes up the pigments formulation, and its total accumulated UV exposure. Depending on these factors the pigment itself can vary in shade over time, ranging from pure white all the way to grey or even black. To suppress this effect, a dopant may be used, such as a small amount of cobalt salts, which would be added to the formulation. This process creates cobalt-doped zinc sulfide. The cobalt salts help to stabilize zinc sulfide so it will not have as severe a reaction to UV exposure.

In recent years, there has been growing interest in the development of novel applications for Chinese anatase titanium dioxide, such as in the field of energy storage and conversion. For example, it has been investigated as a potential electrode material for lithium-ion batteries, due to its high conductivity and stability. Furthermore, its photocatalytic activity has been explored for use in dye-sensitized solar cells, where it can help to improve the efficiency of solar energy conversion.

The additives that received a “no safety concern” conclusion based on current estimated dietary exposure are as follows:

Lithopone 30% CAS No. 1345-05-7

Titanium dioxide (TiO2) is used in a variety of personal care products, including sunscreens, pressed powders, and loose powders, as a UV filter or whitening agent. In lotions and creams (dermal exposure), it is not a risk for adverse health effects. However, when titanium dioxide is inhalable—as it may be when in powder form—it is considered a possible carcinogen by the International Agency for Research on Cancer.Titanium dioxide nanoparticles do not appear to confer any unique health hazards.

The FDA has issued guidance clarifying the safe use of titanium dioxide pigment as a food colorant and has stated that titanium dioxide may be safely used in cosmetics, including those intended for use around the eye. FDA also regulates the safety and effectiveness of sunscreen active ingredients, including nanoscale titanium dioxide.