Failure to install oil seals correctly can lead to failure. Factors such as knocking the seal into place may cause its spring to tilt in the bore or be out of alignment. Consider switching to a solid adhesive and applying it around the surface of the spring to prevent it from loosening.
One way to identify a seal that has not been fitted correctly is to check the rough shear of the rubber. To resolve this issue, align the mounting tool before positioning the seal in place.

■Rust and corrosion inhibitors: Your engine’s internal parts can rust and corrode when exposed to acids and moisture. These additives create a protective film over your engine’s internal parts to help prevent such damage.

Oil seals are often called grease, fluid, or dirt seals. These seals close spaces between stationary and moving components in mechanical equipment. Oil seals are designed to prevent the escape of lubricant. They also block contaminants from entering machinery. This is especially important in severe environments where heat and foreign objects may be frequently present. They also prevent the mixing of different mediums like lubricating oil and water.

ERIKS type M (type B according to the DIN standard) has a single metal casing and rubber sealing lip. Since the casing is made of metal, it must be fitted in a well-finished, undamaged groove. Large volumes of oil seals with metal casings are often cheaper, which is why they are often used as original equipment in machines. However, if an oil seal has to be replaced, types with a rubber exterior (type R or RST) are easier to fit. Type MST is similar to M and commonly used. The difference is the dust lip in the MST oil seal that prevents dust and dirt reaching the sealing lip, and extends its service life in dusty environments.