The global Lithopone market was valued at $169.8 million in 2019, and is projected to reach $218.6 million by 2027, growing at a CAGR of 3.30% from 2020 to 2027.

How pure TiO2 is extracted from titanium-containing molecules depends on the composition of the original mineral ores or feedstock. Two methods are used to manufacture pure TiO₂: a sulphate process and a chloride process.

Natural barite and anthracite containing more than 95% barium sulfate are mixed and fed at a ratio of 3:1 (mass). After being crushed to a diameter of less than 2cm, it enters the reduction furnace. The furnace temperature is controlled to be 1000-1200°C in the front section and 500-500 in the back section. 600°C, the reduction furnace rotates at a speed of 80 seconds per revolution, and the reaction conversion rate is 80% to 90%.

Lithopone B301

In an early study Jani et al. administred rutile TiO₂ (500 nm) as a 0.1 ml of 2.5 % w/v suspension (12.5 mg/kg BW) to female Sprague Dawley rats, by oral gavage daily for 10 days and detected presence of particles in all the major gut associated lymphoid tissue as well as in distant organs such as the liver, spleen, lung and peritoneal tissue, but not in heart and kidney. The distribution and toxicity of nano- (25 nm, 80 nm) and submicron-sized (155 nm) TiO₂ particles were evaluated in mice administered a large, single, oral dosing (5 g/kg BW) by gavage. In the animals that were sacrificed two weeks later, ICP-MS analysis showed that the particles were retained mainly in liver, spleen, kidney, and lung tissues, indicating that they can be transported to other tissues and organs after uptake by the gastrointestinal tract. Interestingly, although an extremely high dose was administrated, no acute toxicity was observed. In groups exposed to 80 nm and 155 nm particles, histopathological changes were observed in the liver, kidney and in the brain. The biochemical serum parameters also indicated liver, kidney and cardiovascular damage and were higher in mice treated with nano-sized (25 or 80 nm) TiO₂ compared to submicron-sized (155 nm) TiO₂. However, the main weaknesses of this study are the use of extremely high single dose and insufficient characterisation of the particles.

Titanium dioxide (TiO2) is a chemically inert inorganic compound and an insoluble white solid that occurs naturally in several minerals, including rutile, anatase, and brookite. It is created synthetically from the mineral ilmenite. It is an insoluble white solid. Anatase, when compared to brookite and routine, has the most industrial applications, but it is the most toxic form of TiO2.

CONSEILS D'EMPLOI

The vitaminC@P25TiO₂NPs, on the other hand, were obtained through an optimized method based on Mallakpour et al. [27]. Initially, 0.02 g of P25TiO₂NPs were dispersed in 1 mL of ultrapure water and stirred in a Vortex. Next, 100 μL of HCl (0.01 M) were added (pH 2) to 100 uL of P25TiO₂NPs to avoid gel formation. Then, 100 μL of vitamin C dissolved in ultra-pure water (5.0 × 10⁻³ M) solution were added to the mixture and was ultrasonicated for 30 min. Finally, vitamin C was added in excess to gain a beige-orange color suspension, and the ultrasonication continued for another 30 min. The pellet obtained after centrifuging the suspension for 10 min at 4500 rpm was resuspended in ultrapure water, centrifuged again, and then lyophilized.

Flavoring Agents

In food, titanium dioxide has a few different uses. Most notably, its food-grade form is used as a colorant to enhance and brighten the color of white foods such as dairy products, candy, frosting, and the powder on donuts. For foods that are sensitive to UV light, titanium dioxide is used for food safety purposes to prevent spoilage and increase the shelf life of food.

What is titanium dioxide? Why is it used in food products?

The most common foods containing titanium dioxide are chewing gum, candies, pastries, chocolates, coffee creamers, and cake decorations (1Trusted Source, 3Trusted Source).

Rebecca Capua